Address by computer name instead of IP address in WireGuard VPN?

[bring.fringe18]

Good stuff. Can you ping your Mac via its WG IP (eg: 10.0.8.2)?

@johnc

WG’s tunnel address is 10.0.8.1/24

---

Reference(s):

Correct calculation of WireGuard client IP?

Thanks. Starting over this time yielded the results I was after. My lan still exists at 10.0.0.x; Brume 2 = 10.0.0.1 WG’s tunnel address is 10.0.8.1/24 (so as not to conflict with the default Open VPN server (which I am not using at the moment)) and I have both masquerading and Allow Remote Access LAN enabled. I took the defaults for the client config. With my iPhone disconnected from wifi, I connected to the VPN and could get to the Brume 2 admin page at 10.0.0.1. Not only that, but I could …