3

(I’m upgraded to the latest firmware, 3.019)

Thanks, that got me further along, but not yet successful. I followed the instructions, uploaded the driver etc. copy/pasted the instructions into putty. My phone was already setup for easytether which I can use from my desktop win10 system, so I think the phone is set up correctly.

I get to the point where I connect the cable, it will say connection established.

Then after about 15 seconds, a message pops up on my phone,

Attention

The connected device is unable to access data on this device. Reconnect the USB cable and try again. I do this and the same thing happens.

At the same time, I’m logged into the web interface from my laptop and it says in the tethering box on the internet tab: no tethering device found.

I logged in via putty and tried to enter the easytether-usb command again after a reboot, and it says,

interface tap-easytether is used by another process (hotplug?)

so I disconnected the usb cable (from phone to router) and tried the
command again,

it then says

acquired interface tap-easytether
no device match (see setup wizzard in easytether on your phone)

Any ideas?