AR300M - WiFi Client mode

Hi, I am evaluating the AR300M to connect a device using Ethernet port to WiFi. I’d like to receive a clarification on the following questions:

1)Does the router support a connection to an existing WiFi router in client mode?
2)In affirmative case, is NAT supported in this configuration? The target WiFi router doesn’t support ‘bridge’ mode, therefore the wired device should receive an IP address from the AR300M

Many thanks for your cooperation!


Hi freddies, I think the chapter Repeater (WISP) on describes what you are looking for. So the answers are : Yes and yes.

Btw check for your evaluation as well!