AT&T (ATT) network fix

robotluo · 2020-03-11T06:53:03.821Z

Please note this post is 2020 and the info is old. Not need to do this in 2021

I have received feedback from users that ATT cannot be used. You can try the following steps.

Step 1:
Enter the AT instruction page and execute the command AT+QPRTPARA=3
$ROXZU%DNUW(9{MDS_9%EMY0$

Step 2:
Confirm the modem version and execute the corresponding instruction

For version R05, execute
at+qfopen="../../usr/fota_ip_a/update_report.ur",1

For version R07, execute
at+qfopen="../../data/fota_ip_a/update_report.ur",1

For EP06, execute
at+qfopen="../../data/fota_ip_a/update_report.ur",1

2750×253 6.79 KB

Step 3:
Execute AT command AT+CGDCONT=1,"IP","broadband"
Then, In modem manual Settings, modify your apn configuration to use broadband and click Apply
}98R}0EB({SGWXO(KV{4D4M

Step 4:
Restart your router

Johnex · 2020-03-11T06:56:18.469Z

frank33v · 2020-11-23T14:49:42.219Z

robotluo:

For EP06, execute at+qfopen="../../data/fota_ip_a/update_report.ur",1

This command does not work…I get CMD error 401. Speeds are horrible and very little CA on AT&T.

Any help?

AT+QPRTPARA=3 is error also.

alzhao · 2020-11-23T16:15:30.175Z

Are you using this command when the model is connected?

frank33v · 2020-11-23T18:55:15.672Z

Yes I am. I assume this is an over the air update. Should it not be connected?

frank33v · 2020-11-23T18:58:15.580Z

I just disconnected and tried again…same error.

+CME ERROR: 410

robotluo · 2020-11-24T06:40:06.757Z

Can you tell me the version number of the modem?
It’s on the modem page.

frank33v · 2020-11-24T11:59:31.136Z

I have flashed back to gl firmware so no modem page. Do you want firmware ver?

AT+CGMR
EP06ALAR02A07M4G

frank33v · 2020-11-24T12:02:24.234Z

ATI
Quectel
EP06
Revision: EP06ALAR02A07M4G

frank33v · 2020-11-26T12:48:10.204Z

Perhaps my unit is defective as it wont stay connected now with my Visible sim either. Can it be returned?

Razorline · 2020-11-26T13:30:45.129Z

Hold the power button till the device does a shutdown. Wait 20-30 seconds and then power it back on and try this again.

frank33v · 2020-12-01T12:21:55.932Z

I had to remove the modem and use a pcie to usb adapter to upgrade its firmware. Works much better now.

These should not be sold/shipped with this outdated version of firmware.

alzhao · 2021-05-27T02:08:43.828Z

This post is old and not needed in 2021.