Brume 2 Wireguard interface error

[bruce]

Hello,

1. Configuring the WG server and client in GL GUI Admin Panel, leave Luci alone.

@maneeshs15

Some forums suggested firewall rule on Luci to allow from wgserver to LAN and WAN. However in my case wgserver zone is empty and doesn’t have wg0 interface type. Error shown is install plugins (luci-proto) which I install but to no avail

2. Regarding you mentioned, are the LAN/WAN subnet 10.0.0.0/8? What is the WG subnet?

@maneeshs15

Private LAN 10.0.0.x that all Wireguard clients need to access

@maneeshs15

On GLI. Inet GUI i disabled the default DHCP server as I dont need it. Basically my Wifi router WAN interface sits on 10.0.0.x subnet and hides clients behind its LAN ip address

Please do not set up the same subnet for WG and LAN/WAN.

4. Please refer the guides to check:
   How to troubleshoot WireGuard
   Build your own WireGuard home server - GL.iNet Router Docs 4

If no luck, please draw a network topology, and marked the IP address of all interfaces.

5. If you require to access WG client LAN in other WG clients, please add the routes in WG server
   VPN Dashboard (Firmware v4.7 and earlier) - GL.iNet Router Docs 4