Gl-ar300m(d)

dvdivx · 2016-07-06T00:47:32.000Z

Do you have an estimate for when the ac part for GL-AR300M(D) will be ready? I’d love this router with the ac part included and either a 2db antenna or a 5db antenna included. Also I did not see any software for it yet. Look forward to buying one in the near future.

alzhao · 2016-07-07T15:03:10.000Z

The firmware is the same as other devices. So you will see a totally same UI, except, the available space will be more than 100MB.

We have a few pieces of the the 5G module. The problem is the open source driver is not very stable now and it is hot. We need to add a heat sink, maybe.

justin · 2016-07-08T09:21:26.000Z

I also can’t wait to hear when the AC module will be released! Looking forward to purchasing many of these in the future.

dvdivx · 2016-07-13T15:26:36.000Z

So with the add on board do I have to solder or is it snap and play? You could use a tiny heatsink like raspberry pi does. And as for the antennae do I need two or just one?

alzhao · 2016-07-14T12:31:02.000Z

@dvdivx, we prefer to solder the 5G add on directly on the PCB, although we are using a small connector now.

You should use two antennae for 2.4G if you want external stick. The 5G module is 802.11ac and it only needs one antenna.

asanori3 · 2016-07-14T20:21:46.000Z

Please tell me 3pins & 4pins assignment.

alzhao · 2016-07-15T10:39:03.000Z

@KOJI, you may refer to https://www.gl-inet.com/products/gl-ar300m/

asanori3 · 2016-07-15T23:47:13.000Z

thank you!