GL-AR300M Wireguard Client

themana · 2020-04-23T21:24:43.082Z

I am trying to connect to my pivpn wireguard setup and the router will never connect. I have copied and pasted the conf file directly from the pi into the web text box. This same .conf file works on the wireguard app on my phone. Below is my conf file with any keys or endpoints taken out.

[Interface]
PrivateKey = ********************************************
Address = 10.6.0.3/24
DNS = 10.6.0.1

[Peer]
PublicKey = *********************************************
PresharedKey = ******************************************
Endpoint = xxxxxx.no-ip.org:51820
AllowedIPs = 0.0.0.0/0, ::0/0

Any help would be greatly appreciated

surabi · 2020-04-29T00:43:50.452Z

How about that: [GUIDE] Connect to cloudflare's free WARP pseudo VPN service using built-in wireguard client

Also did you check on whoer.net or similar sites if it’s might just the Router-UI which shows disconnected but Wireguard is working fine? That happened to me quite often when I used a beta firmware or a snapshot, but fixed itself after a few days.

good luck.

chromebook · 2020-04-29T12:28:42.454Z

Try rebooting the router after creating the config. Also try using the manual input option instead of the text box. BTW the manual input will only accept 0.0.0.0/0 for the allowed IPs (though you can change it after the fact - I’m not sure how well IPV6 is supported on gl.inet’s wireguard currently though).

Johnex · 2020-04-29T14:43:02.892Z

Basically there is no global ipv6 support in the GL firmware for now, be it VPN, or other things. That will change in the future, but for now its not supported.

wellnw · 2020-04-30T02:14:29.873Z

@themana
Can you provide me with a wiregaurd configuration file, I will test it for you , my email address guilin.wang@gl-inet.com

cataclysmic · 2021-02-21T11:24:18.601Z

Hey, @themana just wondering if you were able to resolve this issue? I also can’t get my router to connect to my Wireguard PiVPN server. Thanks

Manual Wireguard client does not connect, works on other devices (PiVPN) — Beryl GL-MT1300 Technical Support for Routers

Got a new GL-MT1300 in order to serve as a Wireguard client hotspot on my PiVPN Wireguard server. Can’t get it to work. Looking in the forums I see another issue specifically on the GL-MT1300. As well as other reports of issues on other routers when using PiVPN Wireguard servers (1, 2). The server and the client configurations work great on mobile devices and desktop I have tested on. When I input manually, or via .conf file, or via QR code using the GL.iNet app, it does not work. It spins on …

witty · 2021-06-03T22:54:45.086Z

GL-AR300M
Firmware Version 3.201
My pivpn config looked like

[Interface]
PrivateKey = xxx
Address = 10.6.0.3/24
MTU = 1420

[Peer]
PublicKey = xxx
PresharedKey = xxx
Endpoint = xxx:51820
AllowedIPs = 0.0.0.0/0, ::0/0

I had to enter a „new line“ after line „ Address =“ and before „MTU =“.

With this minor change, I was able to import config file in the text-field!