Gl-ar750-3.009-1129.bin

bg4drl · 2018-12-01T13:37:44.010Z

gl-ar750-3.009-1129.bin is out

Henry_Bruns · 2018-12-01T13:46:36.368Z

bg4drl:

gl-ar750-3.009-1129.bin is out

See the follow bugs:

Bug Reporting Thread For Firmware v3 - #108 by Henry_Bruns

The other known bugs i didnt tested again.

bg4drl · 2018-12-02T07:44:48.591Z

Both 2.4ghz and 5ghz are perfect. 300/450Mbps connection is normal. Using 2x2 AC8265 and AC9260 are perfect.
However, after the OpenVpn and WireGuard settings, the WAN port cannot be connected properly.
But after the Reset is reconfigured, both VPNs are perfect.

bg4drl · 2018-12-02T08:01:50.610Z

2018-12-02_16-00-391412×607 114 KB

rayx999 · 2018-12-06T04:44:10.380Z

gl-ar750-3.0-1011_clean.bin from GL.iNet download center just BRICK my box. No sign of alive. Only power LED is on. Press reset for 10 seconds can reset the device, but noting more.

How can I unbrick AR750? Is there a way to hack into ROM to load new firmware?

Thanks,
Ray

alzhao · 2018-12-06T06:59:17.986Z

Can you connect using a cable? The clean firmware may not have wifi on.

If you can connect to AR750 using cable then you can ssh to it and do settings, including installing software. I am not sure if luci is installed. If there is luci, you can just flash the stock firmware using luci. Otherwise you need to use uboot.

docs.gl-inet.com

Debrick via Uboot - GL.iNet Docs

Documentation for GL.iNet Productions

rayx999 · 2018-12-06T11:06:26.917Z

No I can’t connect by USB cable, there is no COM port enumerated. When I used 2.272, I could connect.

glitch · 2018-12-06T12:50:06.129Z

I think Alzhao meant ethernet cable not USB cable!

Leo · 2018-12-09T10:22:06.276Z

gl-ar750-3.009-1206.bin is out

Henry_Bruns · 2018-12-09T10:55:30.433Z

gl-ar750-3.x

Any idea where is place for switch on/off the “WLAN coecistence” on gl-ar750-3.x firmware ?
Switching off “WLAN cocistence” doubled the real life WLAN speed on gl-ar75-2.x firmware from little bit lower than 150 MBit to exact 300 MBit on 2.4 GHz.
It can be that will fix the the to 150 MBit limited speed problem on real envirement.

alzhao · 2018-12-10T02:08:27.122Z

That setting should only be used for debug as it violate FCC/CE regulations.

It should be able to set up in uci directly.

option noscan 1