# GL-MT3000 stops working when connecting to Tailscale Exit Node

**URL:** <https://forum.gl-inet.com/t/gl-mt3000-stops-working-when-connecting-to-tailscale-exit-node/34146>\
**Category:** Router\
**Created:** [October 12, 2023, 5:15pm UTC](https://forum.gl-inet.com/t/gl-mt3000-stops-working-when-connecting-to-tailscale-exit-node/34146 "2023-10-12T17:15:16Z")\
**Posts on this page:** 1\
**Showing post:** 3

<div class="post-metadata">

**Author:** ![ikun](https://forum-assets.gl-inet.com/letter_avatar_proxy/v4/letter/i/f07891/32.png) [@ikun](https://forum.gl-inet.com/u/ikun)\
**Post date:** [October 13, 2023, 2:10am UTC](https://forum.gl-inet.com/t/gl-mt3000-stops-working-when-connecting-to-tailscale-exit-node/34146/3 "2023-10-13T02:10:48Z")

</div>

hi,

Could you execute the following commands and PM me the result? There are some seetings needs to be check, like mentioned in post [GL.iNET AXT1800 Tailscale fail to connect - #7 by KingRichard](https://forum.gl-inet.com/t/gl-inet-axt1800-tailscale-fail-to-connect/33403/7)

```auto
 ifconfig
 tailscale status
 ip rule
 ip route show table 55
 ip route

```

---

_[View the full topic](https://forum.gl-inet.com/t/gl-mt3000-stops-working-when-connecting-to-tailscale-exit-node/34146)._