# GL-MT3000 stops working when connecting to Tailscale Exit Node **URL:** \ **Category:** Router\ **Created:** [October 12, 2023, 5:15pm UTC](https://forum.gl-inet.com/t/gl-mt3000-stops-working-when-connecting-to-tailscale-exit-node/34146 "2023-10-12T17:15:16Z")\ **Posts on this page:** 1\ **Showing post:** 42
**Author:** ![Gravity8602](https://forum-assets.gl-inet.com/letter_avatar_proxy/v4/letter/g/76d3ee/32.png) [@Gravity8602](https://forum.gl-inet.com/u/Gravity8602)\ **Post date:** [October 3, 2024, 10:00am UTC](https://forum.gl-inet.com/t/gl-mt3000-stops-working-when-connecting-to-tailscale-exit-node/34146/42 "2024-10-03T10:00:30Z")
I had a similar issue and was able to solve it in a few different ways: > [@Beryl AX (GL-MT3000) using a tailscale exit node](https://forum.gl-inet.com/t/beryl-ax-gl-mt3000-using-a-tailscale-exit-node/47744/4): > > Luci configuration safe. Thank you that is good to know. You can install the TS client in the phone/computer, etc, to verify whether the exit node is available. This works fine, I have been using this exist node with my phone and laptop for a while. If available, please reset router and enable the TS in the GL admin panel, rebind it (let the TS re-create the route table), and in general there are not require configuring anything in the LuCI and SSH. Just to clarify the ssh config I di… --- _[View the full topic](https://forum.gl-inet.com/t/gl-mt3000-stops-working-when-connecting-to-tailscale-exit-node/34146)._