3

Dear Lizh,
Thank you so much, I tried to compered before and after:

  • mwan3 CFG
  • network CFG
  • system CFG
  • all the entire uci show text

No differences
I seen that you have to login in the interface, stop the auto connect, wait that auto connect is topped and then do manual config apply and done. I seen too that if you reboot through interface or ssh it will connect immediately after boot it but if you unplug the power supply won’t reconnect on boot.

attach link with all dumps 24.53 MB folder on MEGA
The video instead describes very well what’s the issue, before i started to record the little MT300 was on for 30 min trying to connect with no success.

If you hvae some suggest i’m here, thx again
Nicolò

P.S.
I forgot to tell you too that K4606 seems to don’t have this problem, perhaps bcz it gose by tethering, idk seems only modem_1_1 interface is effected.