GL-MT300Nv2 Tethering Failover

goliontus · 2021-01-06T13:26:30.897Z

I am trying to setup my GL-MT300Nv2 for LAN and 3G/4G. As discussed in other topics, it detects my Huawei modem as Tethering, which is fine - as long as it works.

However, my question is. When the modem boots it uses my LAN and the traffic through my external modem (tether) is minimal. When I unplug my ethernet cable to test the fail over, that works successfully too.

But, when I plug my ethernet cable back in, after a minute or so I can see that uses LAN again, but traffic through my modem stays very very high “as if” both connections are utilised. I don’t understand why there should be any traffic going through the tethering connection?

Thanks

alzhao · 2021-01-06T16:20:50.147Z

goliontus:

but traffic through my modem stays very very high

What is the traffic?

goliontus · 2021-01-06T17:38:15.544Z

I’m not sure how to figure that out?