# Gpsd address in use using TCP/UTP **URL:** \ **Category:** Router\ **Created:** [March 6, 2026, 1:55pm UTC](https://forum.gl-inet.com/t/gpsd-address-in-use-using-tcp-utp/67499 "2026-03-06T13:55:48Z")\ **Posts on this page:** 1\ **Showing post:** 10
**Author:** ![will.qiu](https://forum-assets.gl-inet.com/letter_avatar_proxy/v4/letter/w/b38774/32.png) [@will.qiu](https://forum.gl-inet.com/u/will.qiu)\ **Post date:** [March 16, 2026, 11:31am UTC](https://forum.gl-inet.com/t/gpsd-address-in-use-using-tcp-utp/67499/10 "2026-03-16T11:31:34Z")
Maybe try resetting your router and going through the steps again? > [@\[howto\] GL-X3000 GPS configuration guide](https://forum.gl-inet.com/t/howto-gl-x3000-gps-configuration-guide/30260): > > My GL-X3000 arrived this week, and I tried to configure its GPS capabilities, since the 5G model contains a pretty nice multi-constellation GPS receiver. The use-case for this is to make the receiver available on the local network via the gpsd protocol, so that it can be used by navigation software/hardware if needed. Of course it is not meant to replace a dedicated high precision GPS, but rather as a backup in case the main GPS fails. It was surprisingly easy to get it configured, so I thoug… I'm not sure if the changes you made based on the other article you mentioned earlier might have caused some issues. --- _[View the full topic](https://forum.gl-inet.com/t/gpsd-address-in-use-using-tcp-utp/67499)._