How to unbrick: openwrt-ar150-2.20.bin

Technical Support for Routers
1

today I got gl-ar150 and when I changed firmware to 2.20 from 2.12 the router got bricked, the wireless does not work, and ethernet is trying to connect and then disconnect, then again same cycle forever

I done 30/30/30 and used program IpScan to get ip of 192.168.1.4

 

when i ping 192.168.1.4 in cmd I get

 

Pinging 192.168.1.4 with 32 bytes of data:
Reply from 192.168.1.4: bytes=32 time<1ms TTL=128
Reply from 192.168.1.4: bytes=32 time<1ms TTL=128
Reply from 192.168.1.4: bytes=32 time<1ms TTL=128
Reply from 192.168.1.4: bytes=32 time<1ms TTL=128

 

Ping statistics for 192.168.1.4:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 0ms, Maximum = 0ms, Average = 0ms

 

I tred to connect with winscp but failed, and there goes all my knowledge of how to do it

 

How can I unbrick this ?

2

press and hold the reset button for 10 seconds and wait the router reset, then start over.

3

after doing 15 second reset the router connects to pc with ethernet but without any response to 192.168.1.1 or 192.168.8.1

 

can you install above firmware and see what happen to you

4

ok I made it following this tutorial
<p id=“yui_3_16_0_ym19_1_1468586709606_3689” dir=“ltr” data-setdir=“false”><span id=“yui_3_16_0_ym19_1_1468586709606_3731”>http://www.gl-inet.com/forums/topic/tutorial-unbrickingupgrading-your-gl-inet/
</span></p>
<p dir=“ltr” data-setdir=“false”></p>
<p dir=“ltr” data-setdir=“false”>thx</p>
<p id=“yui_3_16_0_ym19_1_1468586709606_3692” dir=“ltr” data-setdir=“false”><span id=“yui_3_16_0_ym19_1_1468586709606_3691”> </span></p>