Issues with creating VLANs

[DaWeav]

@RasterizedRadius18

2. I clicked on Network → Interfaces → Devices and I clicked on Configure on the br-lan device. There, I went to Bridge VLAN filtering and I enabled VLAN filtering by checking the box.
   …

So now, I just proceeded to click on Save & Apply at the bottom.

I have the same problem using the Advanced LUCI GUI on the Flint 2 non OP24 version. So when I’m editing VLANs on a bridge device, I “un-checkmark’ the VLAN Filtering checkbox and it applies the configuration just fine.

New firmware version 4.7 being released for beta testing

@bruce I have 4.7 on the Flint 2 and the ‘Enable VLAN Filtering’ checkbox is confusing to me. I think this is related to what @miraben was discussing earlier in this thread about VLAN filtering. Whenever I edit the ‘br-lan’ interface that has some VLANs configured, it automatically puts a checkmark in the ‘Enable VLAN Filtering’ box for the bridge device. When I apply the changes with the checkbox checked, it kills the br-lan network and I have to wait 90 seconds for the changes to be reverted.…