NAS functionality would not be on my list of priorities for you except for limited sharing of movies or music for users that could tolerate complete data loss. Even with USB3, performance will be so-so, vulnerable to ransomware and disk failure, and impair the router functioning as a router.
I’ve been down this road with Asus-Merlin file sharing, and with a single disk Seagate NAS. The Seagate suffered complete data loss twice (failed disk). I’ve moved on to a real opensource NAS with redundancy.
It would be nice if it was possible to set SIM Pincode in QMI Mode. Right now when I select cdc-wdm0 the Pincode field disappears. It works fine if I set the Pincode in standard mode and them switch to qmi, but after a while it asks for PIN again.
Also being able to set txpower in dBm like in Luci would be nice, though I understand than low high etc is easier to understand.
Add in GoodCloud option - add mobile (or not mobile) clients to main node wireguard s2s server (sure with access in all nodes networks and give fast clients config via qr code). So as not to create another wireguard vpn server on the router for clients
Instead of only offering the option of Cloudflare or NextDNS for “DNS over TLS” it would be nice with a custom option. I use ControlD DNS over TLS and can only get it working on the router if enabling AdGuard Home and listing it as the resolver. Would much prefer to skip AGH and enable it directly.
@alzhao Yes - this is what I actually plan to do, but it would be nice if the configuration interface allowed it, like some other firmwares in the wild do (ie. AsusMerlin-WRT).
I did find adguard home lets you specify a custom dns-o-tls address, you will have to delete the whole block list if you dont want any ad blocking though
Yes, I’ve done that too, before, but the latency for DNS responses still seemed higher than I would have expected. Need to check if this can be solved by using stubby directly as recommended.