1

Hi,

Need some support, today I installed for the first time the router, in the morning I could connect normally into wifi, but after one or two hours all my devices were disconnected, I have tried to connect again and I get messages like “couldn’t connect to network” or “couldn’t obtain IP”, I have already executed factory reset and still the same issue,

Firmware 4.5.4

1 Like
2

@admins The same error that happens to me, the beta version on 12/6 was better than this stable version.

1 Like
3

Thanks, I downgraded to 4.5.3, and now it is working, but to be honest, I think I will sell it, I preferred to keep using my Brume 2500 + Wifi Mesh in the house. I didn’t like the MT6000 so far, no improvements in terms of software, still old Aguard home, and the same problems like VPN policies.

1 Like
4

Flint 2 enough storage, so you could upgrade latest version Adguard home

1 Like
5

How? I didn’t see any firmware/soft to upgrade it

6

Manually.

But to be honest: It’s not needed. It’s not like the new version will change anything dramatically.
Just stick with the pre-installed one if you don’t feel like you should mess around using SSH.

1 Like
7

I will create new post a guide when I get a home :+1:t2:

2 Likes
8

It’s better, and there are more resources like SafeSearch. You can choose what sites you want to apply the filter.

Also, Adguard Home, even in the MT6000, records the last 6 or 8 minutes in the log even if you choose to keep logs for 30 days. Totally bad…

9

Thank you!! I will wait for it

10

I found a similar topic so I did not create a new post.

2 Likes
11

Thanks for that, I will try it later