Microuter N300 Connection Speeds by Firmware Version

bussa · 2020-10-11T11:23:45.376Z

Long story short

Ver 3.025 = 300 Mbps
Ver 3.102 = 144 Mbps

I read somewhere that n300 has proprietary mediatek drivers so that it can achieve high speeds. Probably they turned back free driver on latest version. I hope that proprietary will make default on newer versions.

bussa · 2021-04-11T19:52:32.160Z

3.201 final = 144 Mbps

You must use proprietary driver.

gli1308×890 101 KB

Henry_Bruns · 2021-04-11T20:59:03.808Z

bussa:

Ver 3.025 = 300 Mbps
Ver 3.102 = 144 Mbps

I didnt check this by 3.102 gl firmware, a newer WiFi driver are more sucessfull to reduce the occupancy of channels if no need the traffic. So if you try to compare your maximum traffic speed by your way, it can be you have to look on your way, after 2 or 3 seconds after starting a download of a bigger file.

I have seen on other envirements, WiFi 6 was reducing the channel occupancy much lower if not need for traffic, than your sample are showing. It can be newer driver/firmware are doing this for pre WiWi 6 hardware too.

If you like your get shown a higher speed on the way like you are looking on your speed, you can configure some thing on advanced admin menue:

disable 802.11b, if you dont need
configure youre country ( the defoult is set to us. The us have a lower count of wifi chanels than some other countrys.
configure your chanel use to auto ( that protect your for headache about endless dicussion about possible not ideal channel configuration on your router and around you)
set your chanel bandwitch to the maximum available value on your device like 40, 80 or 160 MHz

bussa · 2021-04-11T22:06:21.677Z

Henry_Bruns:

configure youre country ( the defoult is

its all about channel use. N300 sees the source 20 Mhz even though modem was set 40mhz. And as shown in screenshot, bandwidth cannot set 40.