MT-6000 client_loop: send disconnect: Broken pipe

Technical Support for Routers
1

Hello,

since today, when trying to ssh into my MT-6000, I get after a few seconds the message : client_loop: send disconnect: Broken pipe

Then the connection is lost and I get logged out.

I'm using the latest Firmware 4.7.4 rel.6

Is there a solution for this rare behaviour?

Greetings Tom

2

Hi,

  1. Please check if there is an IP conflict of the PC?

  2. If the PC CMD long ping the router IP ping 192.168.8.1 -t, will there be packet loss?

  3. When the SSH connection is lost/logout, can you reconnect again at that moment?

  4. Please try to install others GL firmware like v4.7.0 to see if the issue occurs again?

4

Hello,

thank you for your reply.
I've flashed the router again and the problem was gone.
Sorry for not closing this item.

greetings Tom

1 Like