# MT2500 Wireguard connection using wrong route **URL:** \ **Category:** Router\ **Created:** [July 18, 2023, 6:23pm UTC](https://forum.gl-inet.com/t/mt2500-wireguard-connection-using-wrong-route/31544 "2023-07-18T18:23:07Z")\ **Posts on this page:** 1\ **Showing post:** 2
**Author:** ![bring.fringe18](https://forum-assets.gl-inet.com/user_avatar/forum.gl-inet.com/bring.fringe18/32/11777_2.png) [@bring.fringe18](https://forum.gl-inet.com/u/bring.fringe18)\ **Post date:** [July 18, 2023, 6:41pm UTC](https://forum.gl-inet.com/t/mt2500-wireguard-connection-using-wrong-route/31544/2 "2023-07-18T18:41:30Z")
Don't forget to disconnect & reconnect your WG connection when you change 'priorities' under GL GUI -\> Network -\> Multi-WAN -\> Interface Priority. That seems to be 'the trick' to it for force the changes. Related but your case seems to be the exact opposite of the following issue: > [@\[Bug\] GL GUI: Multi-WAN Interface Priority not honored/have effect](https://forum.gl-inet.com/t/bug-gl-gui-multi-wan-interface-priority-not-honored-have-effect/31443): > > Device: Burme 2 (GL-MT2500) Firmware: 4.2.3 release 5 (OpenWrt 21.02-SNAPSHOT) Goal tethering interface to be the primary Internet connection for the Multi-WAN setup while the Ethernet is also connected to the Burme 2’s WAN port. Issue The Ethernet takes priority for all Internet connections in a Multi-WAN setup but the tethered device offers a faster connection. Interface Priority is reported to have been adjusted within the GL GUI → Network → Multi-WAN → Interface Priority but does not seem… --- _[View the full topic](https://forum.gl-inet.com/t/mt2500-wireguard-connection-using-wrong-route/31544)._