MT300A - DHCP Issue

x-maysonnave · 2016-12-16T18:56:47.000Z

Hi All,

I’m testing my firmware built from the GLI repo and I face some issue :

the wan get it’s ip address, gateway and dnses addresses from our internal dhcp server. ok
the wlan get it’s ip address from the router dhcp server. ok

however the eth0.1 can’t get any ip address. I need to force my laptop to be on 192.168.1.20 to access the router.

Thanks

alzhao · 2016-12-17T21:10:42.000Z

eth0.1 is the LAN. You need to set a static IP, right?

x-maysonnave · 2016-12-19T14:09:46.000Z

Hi,

Yes you are right eth0.1 is the LAN.

I don’t want to set a static IP address as I expected like the wlan0 to get an IP from the router DHCP server.

Thanks.

x-maysonnave · 2016-12-22T12:10:36.000Z

Hi All,

Some feedback.

Tested with the GLI firmware 2.24, no trouble on dhcp on both lan and wlan
Tested with my own compiled version, see the.config here attached, no trouble on dhcp on both lan and wlan
However as I tried to build an appropriate firmware for radiusdesk, http://radiusdesk.com/docuwiki/user_guide/md_on_lede

In this configuration wlan gives me an IP address while eth0.1 doesn’t. I need to investigate on the radiusdesk setup side.

Thanks