MT300N-V2 Firmware

bluewavenet · 2018-01-07T03:53:19.000Z

Finally I have found time to test out the lede-mt300n-v2-clean-2.264.bin firmware release.

The WiFi is now very stable with good performance. Well done to the team, a lot of hard work went into this I can see

One small problem now is the wifi driver dumping loads of debug messages into the kernel log (dmesg)

eg:

[ 4302.798003] Start Seq = 00000048 [ 4306.938063] MtPsWatchDog(): HIT PsmPktCount/Dur: 0/1 on Wcid 2 (SW_PSM:[0|0])

[ 4306.938063]

[ 4369.804423] Rcv Wcid(2) AddBAReq

[ 4369.807715] Start Seq = 00000049

[ 4495.796112] Rcv Wcid(2) AddBAReq [ 4495.799568] Start Seq = 0000004b

[ 4505.794162] Rcv Wcid(2) AddBAReq

[ 4505.797454] Start Seq = 0000004c

[ 4571.804827] Rcv Wcid(2) AddBAReq

[ 4571.808229] Start Seq = 0000004d

[ 4639.795186] Rcv Wcid(2) AddBAReq

[ 4639.798501] Start Seq = 0000004e

[ 4705.798060] Rcv Wcid(2) AddBAReq

[ 4705.801362] Start Seq = 0000004f

[ 4734.558123] MtPsWatchDog(): HIT PsmPktCount/Dur: 0/1 on Wcid 1 (SW_PSM:[0|0])

[ 4734.558123]

[ 4734.558123] [ 4772.795176] Rcv Wcid(2) AddBAReq

[ 4772.798490] Start Seq = 00000050

[ 4840.790531] Rcv Wcid(2) AddBAReq

And repeat etc etc

Probably a simple fix and does not seem to cause any problems.

alzhao · 2018-01-08T18:29:06.000Z

is this working on repeater mode or just ap mode?

bluewavenet · 2018-01-08T18:35:23.000Z

Just AP.