Openvpn bridge client side

Luca1979 · 2019-05-07T16:14:28.324Z

Hello,
is there a way to create a bridge between tun0 and eth0 on the client side openvpn ?? I ask this because the latest firmware version works forwarding but not the openvpn client … I go back to version 3.12 … I tried to create the bridge from the console … it returns is not possible to insert tun0 in the bridge.

Now I use 1. GL-MT300N-V2

Luca

kyson-lok · 2019-05-08T03:52:10.399Z

You can refer to this thread. OpenVPN bridging - #3 by kyson-lok

Luca1979 · 2019-05-08T11:53:08.537Z

Thanks for reply.
So you need to change the server-side configuration, I use a cisco RV320 as a server, but I can’t change the low-level configuration of the openvpn server. Is there any other solution?