Routing between 2 Gl.inet routers

beniamin · 2022-07-10T22:06:01.226Z

Hi friends,
I have a GL.inet SlateAX as my main router, and a GL-AR300M NAND in router mode with (WWAN).

ISP → SlateAX → AR300M (WWAN) → Synology

The 300M is connected to a device without WiFi (Synology).

The AR300M has a subnet of 10.0.0.x/24
The Slate has a subnet of 10.0.5.x/24

On the AR300M, I’ve accepted all the FW zones:

image1919×445 50.7 KB

I can access the AR300 (10.0.5.100) from the Slate.

On the Slate side, I’ve added a route for any traffic 10.0.0.0/24 to use the gateway of 10.0.5.100 but I still cannot access my Synology or the AR300 on its native ip of 10.0.0.1.

image1909×267 21.8 KB

beniamin · 2022-07-11T23:19:34.017Z

@alzhao
Any guidance would be greatly appreciate

wcs2228 · 2022-07-11T23:46:47.557Z

Instead, I suggest you set up Port Forwarding of all the required ports (DSM-5000/5001, SMB, HTTP, HTTPS, SSH, etc.) from WAN to LAN. Alternatively, you can put the Synology NAS in the DMZ that should forward all ports.

I doubt the GL-AR300M as a wireless repeater/repeater will provide much throughput for a NAS, especially only over the 2.4GHz band,.

I do not work for and I am not directly associated with GL.iNet

alzhao · 2022-07-12T11:32:47.986Z

@hilll can you have a check of this one?

hilll · 2022-08-12T02:49:11.588Z

slate ping AR300M wan ip(10.0.5.100)is ok

slate ping AR300M subnet lan gateway(10.0.0.1) is ok?

ssh to slate route, execute command: route

get the route rule.

in the slate can execute command:

traceroute 10.0.0.1

cloud you find the pkg, go to the 10.0.5.100 ?

int the AR300M, will set firewall, set DMZ to access the Synology