S1300 forgets Wifi Configuration upon Reset?

suicune · 2019-08-19T04:14:38.812Z

I have the S1300 and have followed the following…

First Time Setup - GL.iNet Docs 3

Documentation for GL.iNet Productions

When I change the name of the wifi network to something else, it works okay, but as soon as I disconnect the router and plug it back into the wall, it resets to factory settings… how do I get around this? Is this a defect to my product?

kyson-lok · 2019-08-19T06:54:09.783Z

Maybe you had pressed mesh button by mistake? Could you please confirm it?

hansome · 2019-08-19T08:48:05.545Z

What’s your firmware version? Execept for setting wifi ssid, have you do other setting, or intalled some pacakge?

suicune · 2019-08-19T12:51:39.652Z

Firmware version is the default that came with it out of the box 3.023 compiled on 2019-05-23.

I only changed WiFi SSID and password first for 2.4ghz and password (using hit Modify, then Save). Router disconnects and restarts.

I then connect to the new SSID, then modified the SSID for the the 5Ghz (using hit Modify, then Save).

After a day or so… all I did was just unplugged power adapter from wall. Then replugged in.

When I do that, all the settings reset to factory and it asks me to define admin password, etc.

I redefined everything using the same process above and it works fine… but then I unplugged the power adapter from the outlet and replugged in, and it forgets all the settings and auto-resets back to factory settings again.

hansome · 2019-08-19T13:18:14.518Z

Would you please upload the log of command:

dmesg
mount

after boot and make wireless setting?

suicune · 2019-09-02T02:31:59.237Z

How do I enter commands into the router? Is this something I can access through admin control panel? If not, please provide step by step instructions what I need to do.

suicune · 2019-09-02T02:32:51.740Z

No, like I said. I just unplugged power cable and replugged it in. No buttons were hit. Just recently, there was a power outage and the router settings reset back to factory default. This is a very troubling problem, please help.

dzwghx · 2019-09-02T03:47:06.976Z

You need to ssh to the router and enter the command。
Router use SSH:

docs.gl-inet.com

SSH to the Router - GL.iNet Docs

Documentation for GL.iNet Productions