Slate 7 connected to flint 2 as extender

[tomboy07]

Hi all, My slate 7 is connected to my flint 2 as an extender, which works great. unfortunately when i connect to my flint 2 i cannot see the devices o the slate. Flint is 192.168.1.1 and slate is 192.168.80.1. anyone know how to route traffic between them? ta

[9b9e69c2-4b75-4420]

It's been a while but IIRC wireless bridges/aka 'extenders' are required to be on the same subnet. What you're describing is a 'repeater'.

Network Mode - GL.iNet Router Docs 4

[tomboy07]

Yes, you are correct. Any solutions?

[will.qiu]

Hi

May we know now which network mode that Slate 7 running?
If it is the 'router mode' and you are using the Wi-Fi repeater connect the Slate 7 to Flint 2.
Maybe you can refer to this discussion to set up the routing and firewall for your purpose.

Accessing USB flash drive network storage and printing with 2 different subnet network and routers

I wanted to update you on this. I’ve successfully resolved it by resetting both of my routers and applying the configuration you suggested and configuring them as follows: Router Configuration: I have set up the network with a failover configuration instead of load balancing. The GL-B3000 and GL-AX1800 routers are now configured to switch over in case of a failure. Here’s how I’ve set it up: The "repeater" is designated as the primary connection. Ethernet is assigned as the secondary. Tethe…