Hi,
I have a Spitz GL-X750 V2 running on firmware 3.216. I am connected to the internet via the modem and everything works fine. If I do an auto setup for the sim it detects and registers the SIM within a few seconds
I tried updating to v4.2.2 B1 and encountered problems.
- When I upgrade to 4.2.2 and keep my settings, the modem works and I have internet access on the router (checked using the ping tool in Luci). However no devices connected to the Spitz get internet access.
- When I upgrade using clean settings, reset the firmware after the upgrade, try and configure the modem with auto setup or manual setup, the modem does not work. It is unable to register sim and connect to internet. The log gives items like…
Mon May 8 19:55:49 2023 daemon.notice netifd: Interface 'modem_1_1_2' is setting up now
Mon May 8 19:55:50 2023 daemon.notice netifd: modem_1_1_2 (14592): Waiting for SIM initialization
Mon May 8 19:55:51 2023 daemon.notice netifd: modem_1_1_2 (14592): Device does not support 802.3 mode. Informing driver of raw-ip only for wwan0 ..
Mon May 8 19:55:51 2023 daemon.notice netifd: modem_1_1_2 (14592): % Total % Received % Xferd Average Speed Time Time Time Current
Mon May 8 19:55:51 2023 daemon.notice netifd: modem_1_1_2 (14592): Dload Upload Total Spent Left Speed
Mon May 8 19:55:51 2023 daemon.notice netifd: modem_1_1_2 (14592):
0 0 0 0 0 0 0 0 --:--:-- --:--:-- --:--:-- 0
100 138 0 62 100 76 553 679 --:--:-- --:--:-- --:--:-- 1254
Mon May 8 19:55:51 2023 daemon.notice netifd: modem_1_1_2 (14592): Starting network modem_1_1_2
Mon May 8 19:55:51 2023 daemon.notice netifd: modem_1_1_2 (14592): Unable to connect IPv4
Mon May 8 19:55:52 2023 daemon.notice netifd: modem_1_1_2 (14658): Stopping network modem_1_1_2
Mon May 8 19:55:52 2023 daemon.notice netifd: modem_1_1_2 (14658): Command failed: ubus call network.interface notify_proto { "action": 0, "link-up": false, "keep": false, "interface": "modem_1_1_2" } (Permission denied)
Mon May 8 19:55:52 2023 daemon.notice netifd: Interface 'modem_1_1_2' is now down
- When I click on ‘Network-Interfaces’ in luci I get the following message:
'Network ifname configuration migration' The existing network configuration needs to be changed for LuCI to function properly.
Upon pressing "Continue", ifname options will get renamed and the network will be restarted to apply the updated configuration.
Are these known issues? Or are there things I can do to get it working?
thanks