Visible sim on x1200?

crholliday · 2021-02-27T00:29:40.873Z

Anyone know how to setup a Visible SIM on an X1200?

I just get SIM card not registered

crholliday · 2021-02-27T03:00:53.325Z

I’m using an EP06 modem and have been trying the solution from the below link but I don’t think there is a 1 to 1 between the commands on that router and the X1200. I could be wrong but I can’t get it to work.

GL-MiFi or MUDI with Visible Technical Support for Routers

Hello @ardiross , Are you copy and pasting the commands by any chance? You have to manually type them in… The commands are run at 2 First I changed these settings manually in the admin page of the router: TTYUSB3 LTE/UMTS/GPRS VSBLINTERNET (I typed this where you chose the apn on MUDI) then AT+QPRTPARA=3 AT+QMBNCFG=“AutoSel”,0 AT+QMBNCFG=“Deactivate” AT+CFUN=1,1 After running AT+CFUN=1,1 the modem will reset so return to the router homepage and wait then enter the following commands: …

crholliday · 2021-02-27T16:47:59.702Z

I am setting this up per those instructions:

using USB3 as Device doesn’t work if I have to use USB2 for the port when executing AT commands? So should I use USB2 as the device and execute the commands against USB3? What do I do when I am done executing commands? Should I reboot the Amarok or reset the modem? Something else?

image987×561 18 KB

Currently, it does not say Sim card not registered. But it is not serving internet either.

alzhao · 2021-02-28T08:21:48.733Z

ttyUSB2 or ttyUSB3 can be used interchangeably.

If you use one for data and you should use another one for AT command.