I took the router back to factory default and started from scratch. I synced the time with router and then I I went to KeepSolid and created a brand new wireguard config file. I created a config for a server in Illinois and connected the wireguard client and it worked. I also installed an earlier config from Washington but did not renew it on Keepsolid. I ran the old config for Washington and I experienced the same abort issue. I then tried the new Illinois config and bingo—it connected. I am writing this post using my Illinois VPN connection.
Following your advice “Keepsolid is that their Wireguard is a bit flaky - your configurations may change without notice and will need to be regenerated in your management panel”
I can’t say for sure I solved the problem if I power down the router but for right now I am connected.
I am going to not power down this router for a few days and see if I loose the connection or not or if the problem re-surfaces.
Thanks for all your help