Wireguard server stoooed working

ludeke · 2020-10-14T21:58:32.679Z

I have 2 Gl-inet 300 routers inatalled at two locations that I use as wireguard servers. Both have been working for several months but in the past few days one of them stopped working. I had thought that the ISP IP address might be the problem but I changed the address on the client but no difference. I am able to remotely access the router and I created a new QR code and added that as a tunnel but it also did not work. (I am not able to remotely access the working router - customer service could not figure out why either). Any guidance would be greatly appreciated.

fillipo · 2020-10-15T01:33:27.367Z

I wanted to add I’ve been having the exact same issues. Using wireguard client for a year without any problems but suddenly the last couple days I cannot use it. I used the automatic method for both mullvad and azire and even tried manually inputting.

It will connect but always drops within 5 minutes. I wonder if wireguard was updated and the routers need an update as well.

This is not an isolated incident for the op. I changed nothing and it suddenly had issues.
Hopefully the issue can be found because it certainly does exist within the router.

ludeke · 2020-10-15T03:02:35.762Z

What is odd that it works on one of my two routers. Both were purchased back in March.

alzhao · 2020-10-15T03:32:45.390Z

As wireguard does not have logs, are you able to generate a client QR or config for me to test?

alzhao · 2020-10-15T03:33:22.984Z

He is talking about wireguard server and you are talking about wireguard client. It is different. Pls put in a different thread.

alzhao · 2020-10-15T05:05:25.417Z

I recorded your wireguard confirm and deleted your post. You’d better send the config privately.

I’ll contact you privately and check if we can solve