Ar300m16-ext UBOOT issue

[whjte]

hey everyone,

I have the following issue with my GL-AR300M16-ext - whenever I enter UBOOT and upload the firmware 4.3.18 (openwrt-ar300m16-4.3.18-0823-1724390996.bin) it installs it properly, however, after the installation I end up in the same UBOOT (the left and middle green lights on the router are constantly emiting light, as opposed to the normal boot left green and right red light).

I followed the official video from GL.iNet on YouTube, but it never says if there's something else that's needed.

In addition I've enabled the switch and selected the NOR flash, at it seems, that the model doesn't have NAND:

GL-AR300M Series - GL.iNet Router Docs 2

I'll upload some photos tomorrow of the process, as well, but in the mean time, please advise.

[bruce]

Please try to flash the uboot img in the http://192.168.1.1/uboot.html, and then flash the firmware in the http://192.168.1.1

[whjte]

I know flashing uboot img can brick my device, so I have to ask, which one is the correct image for my model: GL-AR300M16-ext?

[whjte]

flashing UBOOT worked, thank you!