This version introduces a new UI for VPN. I have two VPN clients set up, one to my home router and another using NordVPN. When I updated the firmware, the VPN page shows my home VPN client as default. I can't, for the life of me, see where/how I enable a different VPN client even though one is already set up.
Any assistance is appreciated. For the time being, however, I'm rolling back to 4.7.4
Hello,
Since the VPN feature in v4.8.0 has been refactored, VPN-related configurations need to be re-configure after the upgrade is completed.
It is not compatible with v4.7.x or previous versions of configuration, even if "keep settings" is checked during upgrade v4.8.x firmware.
The new VPN GUI of V4.8 provides such great flexibility and beautiful graphics. I also have 2 VPN set up, one for the home network and another for everything else. Here is my setup:
VPN1 (primary tunnel): Wireguard to home network. The target is limited to home network IP range only
VPN2 (secondary tunnel): OpenVPN to internet for all targets.
Non-VPN Tunnel: Disabled.