Cannot access router after 4.8 upgrade and vpn connection

[bruce]

Hi,

I did not reproduce this issue, if I did not misunderstand, I tested it on Flint2 v4.8.x:

I can't access my cameras since updating to firmware 4.8.0

Hi, My test topology is: [Bruce_2025-08-13_16-37-44] MT6000 with v4.8.1 (snapshot) and v4.8.0-op24 (beta) as the test router, and the policy rules are similar with your screenshoot: [Bruce_2025-08-13_16-39-17] [Bruce_2025-08-13_16-39-31] [Bruce_2025-08-13_16-39-46] When MT6000 enabled the VPN tunnels in policy mode, my phone is able to access the MT6000 GL GUI and the Web server by MT6000 WAN IP + port. How to reproduce this issue about unable to access the MT6000 LAN clients by WAN pu…

Are you referring to fail to remotely access the GL router GUI through modem WAN IP or through VPN IP (the VPN connection has been established)?

@packetmonkey

I could still access the devices over the wireguard VPN, but I could not access the router at all. Not via https, not via ssh. The only way I regained access to the router itself at that point was to remove the SIM card and reboot with no WAN so the VPN would not connect.