I’m actually tring to configure access to my modem UI on internal network.
When the “Block Non-VPN Traffic” is enabled I cannot access to https://10.0.0.1 also if the IP is in the same subnet of my gli.
Please find below a draw of actual configuration.
Do you have any suggestion to leave the “Block Non-VPN Traffic” active but mantaining access to modem?
Thank you so much
Please not all together!
I’m sure I’m doing something trivial wrong
Can you check this solution
This looks like the issue I have, kinda sucks I basically can’t use the internet kill switch if i need to access the lan
I’m new on the forum., is this likely going to take a long time to implement? i’ve just read that i could get a different device from my slate a1300 and downgrade to a v3 firmware that was more “logical” with exceptions for VPN policies.
Currently “Block Non-VPN Traffic” will void the “allow access wan” option. You need to configure in luci to achieve what you need.
Thanks a lot
I’m trying to do it and I will let you know
@alzhao, it works!
Thank you so much!