Flint 1, eth ports seems isolated after enabling vlan

[will.qiu]

@soyunplayer

I think the problem may be that I have added DNS blocklists in adguard and that sometimes eats up a lot of memory.

For AdGuard Home, you can refer to the following configuration to help mitigate the memory overflow issue.

Adguard crashes all the time: out of memory

Hello, If ADG enables more large Filter rules, it will occupy a lot of system resources, affecting system stability, and ADG itself will not worry about memory usage, causing if the longer the ADG runs, the greater the resources it will occupy. If possible, try adding a memory limit: Add the procd_set_param env GOMEMLIMIT=100MiB GOGC=40 , on this configuration /etc/init.d/adguardhome. [5593b095216b947e25039bc7e2371fbc]

We plan to add some limitations in future versions to address this problem.

GL-MT3600BE: AdGuard Home "Disk Full" Error When Adding Blocklists

Hi This is a storage usage limit for AdGuard Home introduced in our newer firmware versions. The main purpose is to limit the number of rules loaded, preventing excessive memory usage that could lead to sluggish performance, application crashes, or even system instability. Currently, we will: Roll out this measure to additional models through future firmware updates. Set reasonable limits based on the available memory of each device. The limits we’ve set are relatively conservative—aimed a…