Updated to 4.8.3, same issue… Speed limited to 1Gbps…
root@GL-MT6000:~# ethtool eth1
Settings for eth1:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
2500baseT/Full
Supported pause frame use: Symmetric Receive-only
Supports auto-negotiation: Yes
Supported FEC modes: Not reported
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
2500baseT/Full
Advertised pause frame use: Symmetric Receive-only
Advertised auto-negotiation: Yes
Advertised FEC modes: Not reported
Link partner advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
2500baseT/Full
Link partner advertised pause frame use: No
Link partner advertised auto-negotiation: Yes
Link partner advertised FEC modes: Not reported
Speed: 2500Mb/s
Duplex: Full
Port: MII
PHYAD: 1
Transceiver: external
Auto-negotiation: on
Current message level: 0x000000ff (255)
drv probe link timer ifdown ifup rx_err tx_err
Link detected: yes
The issue is coming from the WAN port, I’ve done an iperf3 in the LAN and the speed is ok… Is something related to the connection:
Speedtest by Ookla
Server: Aruba S.p.A. - Arezzo (id: 40515)
ISP: Aruba Broadband
Idle Latency: 19.97 ms (jitter: 0.11ms, low: 19.84ms, high: 20.09ms)
Download: 1036.96 Mbps (data used: 1.2 GB)
170.52 ms (jitter: 64.38ms, low: 19.68ms, high: 994.31ms)
Upload: 477.29 Mbps (data used: 836.0 MB)
23.65 ms (jitter: 4.91ms, low: 19.65ms, high: 163.38ms)
Packet Loss: 0.0%
I think that I’ll roll back to 4.7.7, forever at this point…