Flint 3 Vlan

[adamsrosco]

I am struggling to create a vlan off one of the ports on the Flint 3.
following this guide: [OpenWrt Wiki] Guest Wi-Fi using LuCI

Device keeps pulling getting assigned an ip from the main DHCP. I dont see an option to exclude the bridged Lan, but alas...

[bruce]

Hi,

Please refer to this post:

VLAN with Flint 2

Okay lets start from the basics then. So I go make two tutorials one with a wired port and one as routed ap. Because maybe vlans are not the right terminology for this use case, what you look for is a routed ap. For Vlan: click here to open For RoutedAP: click here to open There are a few issues to note about gl firmware: the clients menu doesn't work for custom interfaces it listens to (lan,guest). vpn policies may have incompatibilities. ^ some of these things will be fixed at a later…

[adamsrosco]

So resolved the issue, the Ethernet ports are numbered in reverse, so port 4 on the physical device is actually port 1 on LuCi interface. So all is well. Managed to setup my Vlan in bridge mode correctly and gets the new dhcp assigned correctly

This is specific to the Flint 3, BE9300

[bruce]

It's true. I just tested it, and let me show here:

LAN ports in switch1:

switch1	port 1	port 2	port 3	port 4	port 5	port 6	port 7	port8
Number of 2.5G LAN	/	/	/	4	3	2	1	/
Physical Order of Casing	/	/	/	5	4	3	2	/

The 2.5G WAN is eth0, 1 in Physical Order in Casing.

If possible, could you please show us configure process and configuration?

[adamsrosco]

Hi, I dont have access to the ports at the moment, but followed this tutorial. Instead of adding it to the wireless card, I went to "switch" section and added a new VLAN where CPU1 was tagged (as it needs to be tagged on all VLANS, and then made 1 untagged and the rest off. You will need to update the previous VLAN entry to "off" for the port you are using in the new VLAN as you cant have a port assigned untagged on multiple VLAN entries.

and voila!