I am struggling to create a vlan off one of the ports on the Flint 3. following this guide: [OpenWrt Wiki] Guest Wi-Fi using LuCI Device keeps pulling getting assigned an ip from the main DHCP. I dont see an option to exclude the bridged Lan, but alas...

So resolved the issue, the Ethernet ports are numbered in reverse, so port 4 on the physical device is actually port 1 on LuCi interface. So all is well. Managed to setup my Vlan in bridge mode correctly and gets the new dhcp assigned correctly :slight_smile: This is specific to the Flint 3, BE9300 …

GL.iNet Official Forum

Flint 3 Vlan

Routers

KB

bruce July 29, 2025, 7:19am 2

Hi,

Please refer to this post:

VLAN with Flint 2 Routers

Okay lets start from the basics then. So I go make two tutorials one with a wired port and one as routed ap. Because maybe vlans are not the right terminology for this use case, what you look for is a routed ap. For Vlan: click here to open For RoutedAP: click here to open There are a few issues to note about gl firmware: the clients menu doesn't work for custom interfaces it listens to (lan,guest). vpn policies may have incompatibilities. ^ some of these things will be fixed at a later…

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled