My GL-AR150 can no longer broadcast, or connect to, wifi networks.
I’ve attempted to reset the wifi configuration through ethernet.
I have no disconnected/reconnected the antenna while the unit is powered, as some have suggested that has caused damage.
Any suggestions? Thank you
Try doing a factory reset (Revert Firmware) or even 2 or 3 times. If wifi is not working afterwards, then the device is probably gone.
I do not work for and I do not have formal association with GL.iNet
Yeah unfortunately I’ve done 15+ factory resets to no avail. What are my options at this point?
Can you ssh to the router and get the log using
I cannot ssh into the router because after the factory reset it doesn’t broadcast SSID. I also am unable to connect to it via Ethernet at the default config page 192.168.8.1
But can you ssh to 8.1? Download putty and try this before giving up. Also try ping 192.168.8.1 when manually adding your computer’s lan interface on this range, lik 8.4
What IP do you get from the router via cable?