GL-MT3000 stops working when connecting to Tailscale Exit Node

[mikeuk]

Thank you, this fixed it for me with my new Beryl AX running 4.6.4 - is the gl.inet team aware of this issue? There are so many broken things out-of-the-box with this device I'm honestly thinking of returning it.

[Gravity8602]

I had a similar issue and was able to solve it in a few different ways:

Beryl AX (GL-MT3000) using a tailscale exit node

Luci configuration safe. Thank you that is good to know. You can install the TS client in the phone/computer, etc, to verify whether the exit node is available. This works fine, I have been using this exist node with my phone and laptop for a while. If available, please reset router and enable the TS in the GL admin panel, rebind it (let the TS re-create the route table), and in general there are not require configuring anything in the LuCI and SSH. Just to clarify the ssh config I di…

[op123]

I am not able to access the internet after the LUCI changes

[qatar2022]

thank you @Cfm765 that's also works for me

[sammutd88]

This is magic right here and has solved my issue. Thanks a lot. Clearly wasn’t anything in my tailscale config at either end.

[link2rn]

Kudos to you @Cfm765. Idk why Gl-inet is so dumb to make this feature feasible if they are adding as plug-in. Hats off! I might experience slow network bandwidth but it works!