GL-MT300N-V2, change mac address not working

[gorillamath]

I have three GL-MT300N-V2 routers. I cant get the mac address clone feature working on any. I am attempting to change the address to a specific mac address. I hit apply > I get a confirmation message that it was applied.

The setting never actually saves. I have the router in repeat mode, updated to the newest version.

Any advice? I am comfortable with SSH, coding, etc…

[yuxin.zou]

Do you have LuCI installed? This will also help.

750m travel ac router - mac clone dont work

Are you referring to gl-sdk4-macclone? It is system software. You may not be able to reinstall it, it has not been uploaded to the repository. it isn’t use other plug-ins. it only set MAC in OpenWrt. You also can do it in the page of LuCI: [image] Note: You need to find the corresponding device in the “Interface” tab. LAN always use br-lan, but WAN don’t always use eth0.

[alzhao]

What is the firmware version you are using?

Can you try firmware 3.215?