GL-MT6000 Flint 2 - Can't see Clients from added IOT network in GL-iNet GUI

Running original firmware 4.6.2

With a lot of help I have set up an additional IOT network on my Flint 2. I have placed the router in service, and everything seems to be running better than with my ancient Netgear R7800. I am very pleased.

My setup has the default networks set up by GL-iNet. The primary and guest networks with each on their own subnet. My additional IOT network is on its own separate subnet also.

Under the CLIENTS section of the GL-iNet GUI the display shows all online and offline clients from the primary and guest networks, but not the IOT network.

1 - How do I get the clients from the IOT network to show up? What settings or configurations need to be made?

2 - Also, many clients that do show up have "unknown" shown as their name. How can I associate a name with the MAC address so it shows up in the display?

Thanks in advance for your help.

As far as I remember, the GUI is hard-coded, and you can't expand it to show other VLAN clients as well. I am sorry.

You can just edit the entry to assign a name and type:

Interestingly enough, the GL-iNet GUI under WIRELESS does pick up the new IOT 5.0 and 2.4 radios and makes them modifiable in the GUI. This is the reason I am hoping the CLIENTS section can be modified to pick up and display the IOT network clients.

Currently the Client list of the GL GUI does not support to display the client of the custom add Wi-Fi radio or subnet LAN.

1 Like

Bruce - OK, thanks for confirming. Admon - thanks for your guidance.

1 Like