I have tried setting up the ethernet connection many times since I received the GL-RM10. The ethernet on the screen is always yellow. I was not able to set up wired connection. The wifi connection works, but once I inserted the ethernet cable, the connection broke since ethernet received higher prio…

I think the only thing you can still try as round for elimination is removing the power wire wait a few seconds or even better powercycle without the power coord in, you could just tab screen for the little power to be gone if any. Then put in power, if it then still doesn't work, and you also elim…

You can export the logs and send them to flora.wan@gl-inet.com . [设备日志导出]

I followed the instructions from the customer service. However, the ethernet connection is still broken. I tried: /etc/init.d/S98multi-wan restart, no luck. I am sure my router and ethernet cable are functioning normally after testing them with other devices.

Could you try firmware version 1.8.1? That version should have a fix.

The latest one is 1.8.0. Where can I find 1.8.1?

You can find the 1.8.1 beta firmware in this post. [image] RM1/RM1PE/RM10: V1.8.1 Beta1 is currently under testing KVM https://fw.gl-inet.com/kvm/rm1/testing/glkvm-RM1-1.8.1-0206-1770368458.img https://fw.gl-inet.com/kvm/rm10/testing/RM10-1.8.1-beta1.img h…

I installed 1.8.1, the ethernet still does not work. I saw yellow sign, and no connection if I turn off wifi.

Please try executing the following command: /etc/init.d/S98multi-wan stop. After executing this command, the network icon on the screen will always be displayed in yellow. Please check your actual network status.

I tried this command. The ethernet still does not work.

Please enter this command: ip route show to check if the device's routing table is normal.

GL-RM10 Ethernet not working, device defective?

KVM

_zhang March 11, 2026, 2:55am 7

You can find the 1.8.1 beta firmware in this post.