GL-X2000 Multi-WAN configuration

[psigli]

Hi, is it possible to assign a LAN client to a specific WAN interface?

[will.qiu]

Hi

Please see:

Source based Multi-WAN Routing

Hi Yes, right. Load balancing does not make much sense in your scenario. The session will be randomly assigned to either ISP1 or ISP2 until disconnected. This can be achieved using ip rule in failover mode. Please SSH into the router and run the following commands: # 192.168.8.201/32 is the address/subnet for devices using ETH2 # Traffic originating from this address/subnet should be matched using route table 100 with priority 10. ip rule add from 192.168.8.201 table 100 prio 10 # Add a …