How to Configure GL.iNet Router to host Tailscale Exit Node

[will.qiu]

You may refer to this tutorial for configuration, but note that this is an advanced usage. Since it is not yet officially supported, it may be unstable or require frequent maintenance.

Route Tailscale Through VPN Connection

Hi I assume you already know how to configure GL.iNet as an exit node. If you need assistance on this side, please refer to the following thread for configuration. Here are the steps to further adjust the configuration to make with Tailscale exit node work with WireGuard VPN: In Luci - Network - Firewall - Zones, configure tailscale0 to allow forwarding to wgclient1. [image] In Luci - Network - Routing - IPv4 rules, add the following two rules: 2.1 Forward outbound traffic from the …