I wanted to test a Huawei E3372 with v21 firmware (serial mode), so it works in serial mode. But it wont show up in the GLInet web interface for Brume 2 on fw 4.5.0:
Dmesg:
lsusb:
Shouldnt it work out of the box? It has fw E3372h-153_21.180.01.00.00
When I manually add this to /etc/network:
config interface ‘wwan’
option mode ‘preferlte’
option apn ‘internet.telekom’
option dialnum ‘*99#’
option username ‘telekom’
option password ‘telekom’
option proto ‘ncm’
option ifname ‘wwan0’
option device ‘/dev/ttyUSB1’
option ipv6 ‘0’
option metric ‘40’
option delegate ‘0’
option disabled ‘0’
with /etc/init.d/network reload I get this for ifconfig:
But cant ping through it. It also doesnt seem to get ipv4:
udhcpc --interface=wwan0 -q
udhcpc: started, v1.25.1
udhcpc: sending discover
udhcpc: sending discover
udhcpc: sending discover
and stops
Logs show this:
not sure what wwan_4 is it is not shown under ifconfig
Log shows 3 times again this
Thu Jan 25 01:30:29 2024 daemon.notice netifd: wwan_4 (3473): udhcpc: sending discover
and doesnt get an IPv4 ip.