Mesh Compatibility B1300 B2200 AP1300 - mix and match devices on mesh

[gmonaco]

AP1300 has mesh functionality but not an hw button to trigger.
Needs to be triggered by CLI with this command:

ACTION=released BUTTON=wps SEEN=5 /sbin/hotplug-call button &

I personally use a mesh network with both Cirrus (central node) and Convexa-b (3 routers) See this thread:

Mesh with 2 B1300 + 1 AP1300

Hi All, I have GL routers in multiple sites, connected together via GoodCloud S2S. One of the “minor” site is using Cirrus with LTE modem, since it does not have fiber connection. In this site I have 3 routers that I would like to connect and configure enabling Mesh through all of them. One is Cirrus AP1300 and the other two are B1300 (Convexa-B). Are they compatible to be used in the same mesh network, or I can configure only the two B1300? I don’t see any Mesh menu on the Cirrus, althoug…

AP1300 also has bluetooth in 3.217, at least if you buy the version with the LTE modem.
Support for mesh and bluetooth is not continued in the 4.x firmware, because of closed sources.

Thanks a lot,
Gianluca