Hi,
I just upgraded my Puli (with EP06-E) to firmware 3.201 and I am trying to enable IPv6 on my WWAN interface and I noticed that when I am using qcm
as a protocol I can’t get a IPv6 address on the interface:
When I switched to protocol auto
(3g
) I am immediately able to obtain public IPv6 address from ISP, but issue is that with auto
protocol my connection speed is less then half of the speed I can achieve compared to qcm
. Is there anything else needed to configure in order to get IPv6 working with qcm
protocol, please?
Cheers
Vlad