Setup VLAN on Opal Gl-SFT1200

Technical Support for Routers
1

Hi Everyone!
Sorry If I am posting already asked question. But I am stuck and confused new to this world. Howevr my use case is that : I have setup 3 VLANS 40,50,60 on OPnsense LAN interface . I was using these VLANS through Netgear smart switch and all were working.
However Now I want to access these VLANS over WIFI so purchased this device.
But I am bit confused and stuck I hvae setup VLAN on Netgear switch as
Trunk port -8
Port 1 VLAN 40
Port 2 VLAN 50
Port 3 VLAN 60

I already setup SFT1200 in Access point mode from router mode. I am trying to bypass Netgear switch and pass all these VLANS from SFT1200.
I already attched OPnsense lAN cable to SFT1200 WAN and getting traffic and assigned interface Ip 10.10.10.0/24 . However when tried under switch option on Luci like Tagged WAN port and untagged Port 1 not getting VLAN40 IP .

Created custom VLAN40 interface , Assigned to SWITCH setting in Luci however still not getting expcted IP 10.10.30.x

interface
interface1984×246 42.1 KB

Any help and guidance appreciated . Thanks

2

This is probably swconfig (bear in mind I'm not good with swconfig it's before my time using vlans😋)

What happens if you set protocol to dhcp?

You have set a dhcp server on the other side? then you must see it generates a lease.

If not, is the firewall zone on the other side having the input field set to accept?

I believe tagged vlans even with swconfig can just be called as eth0.id idd, if eth0 is supposed to be the wan device, the quick dhcp check can help alot, if it then doesn't work you need to tag it to the cpu?

Also for the switch in question:

You are sure the vlan also tags back to port 1 back to opnsense?

Thats often where i make most of my mistakes :slight_smile: