About every 2 weeks without having made any changes my Beryl router no longer talks to Tailscale and requires a full re-install. This is really irritating especially if I’m away from home and require connectivity.
Hi,
Since Beryl - MT1300 is not on our supported list of GL Tailscale, we assume you are using a third-party Tailscale application.
Please try contacting the application's author for support, or consider writing a script to automatically restart the Tailscale when issues occur.
May we know this is a typo—it should be Beryl AX - MT3000, not Beryl - MT1300?
Alternatively, did you manually install gl-sdk4-tailscale on Beryl - MT1300?
When this issue occurs again, please:
-
Let us know the model and the firmware version.
-
SSH into the router and run the following command, then share the results with us:
tailscale status
-
Export the device logs and send them to us via private message.
How to export the device logs
How to PM:
-
Please make sure that "Disabled key expiry" in the Tailscale Admin Panel. Otherwise, manual reconfiguration is required after key expiration.
This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.